![]() A new mounting hinge needs to be made, and a suitable bracket for fixing the front of the cover needs to be fabricated. ![]() Change gear cover as seen in the photos only has a temporary fixing to it as the previous owner had used the lathe without the cover fitted.Please note the following points about this lathe It could be wired for forward / reverse operation if the wiring is replace with 5 core cable, and a suitable switch is used. It is wired for forward operation, and has a standard 3 pin plug fitted. ![]() The motor is a single phase 240V 1420 RPM Cub Motor rated at 1/3HP. Sundry items – spanners, nuts, washers, bolts, gear spindles etc.Travelling steady frame – no fingers, I think the ones from the fixed steady can be reused.Fixed steady with 3 fingers – note that the plate needed to go under the bed to secure this steady is not present. ![]() The makers plate on the right hand end of the lathe shows that it has the serial number 029920.įurther information about this type of lathe can be found on the .uk website, so please do take a read of that for further information.Īlso included are the following accessories This is an Atlas 10″ lathe with the model number TV36 indicating it has taper bearings in the headstock with a vertical countershaft and a 36″ bed length. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |